The installation methods suit for our SMC, Galvanized Steel Steel Tank and Stainless steel panel type water tanks.
Step 1. Install steel channels on leveled concrete foundations. Welding four outside U-steel first, and then weld inner U-steel.
Step 2: Assemble the panels. When assembling each side panel, make sure the vertical and horizontal side is exactly in same level.
Step 3. Place rubber sealant from ready-to-use roll between panels.
Step 4. Connect panels with bolts and nuts, fasten all bolts to forbid the side panel fall off.
Step 5. Position bottom panel sections, and finish up base of tank.
Step 6. Position three sides of the tank.
Step 7. Position and fix roof panels and if required, roof support pipes and plates.
Step 8. Assemble the water lever meter.
Step 9. Assemble the flange. The flange hole open before dip galvanizing, please supply the diameter when order it.
Step 10.Assemble the ladder, use the fasten clamp to make sure the hole of bolts. And then drill hole, fasten the ladder on it through 4 clamps. Make sure its place is near the manhole.